Output Bin Full; Remove Printed Paper - Samsung CLX-6220 Troubleshooting Manual

Code
01-017
Symptom
When the tray limit is reached, the out-bin full sensor is on for 600ms.
Possible Cause
1. Check the Out-Bin Full Sensor.
2. Check if the UI message is changed by the Out-Bin Full Sensor operation.
3. Check the Out-Bin Full Sensor Harness and Connector.
Troubleshooting method
1. Check the BIN_FULL_SENSOR (picture'1' below) by pushing the trigger (picture'2' below) beneath the SCAN_
ASSY.
Check if the UI message is changed by the Out-Bin Full Sensor operation
2. Check if the Harness is defective.
Check if the connector is connected properly.
3. Replace the Main PBA or the Scan_Joint PBA or the Panel PBA.
4. Enter the EDC mode and follow the below sequence after the repair is done.
( EDC Mode Test Routines
Service Manual
Alignment & Troubleshooting
Error message

Output bin Full

Output bin Full.

Remove printed paper

1
101-Clutch
2
0190-OutBin Full Start
4-38
Status check Stop )
Samsung Electronics