NordicTrack A.C.T. Elite User Manual page 9

3. Have a second person lift the Right Pedal (9)
and the Right Pedal Arm (15).
Using a plastic bag to keep your fingers clean,
apply some of the included grease to the right
Link Arm Bracket (43) in the location shown.
Tip: Avoid pinching your fingers. Slide the right
Link Arm (8) onto the right Link Arm Bracket (43).
Attach the right Link Arm with two M10 x 50mm
Bolts (100) and two M10 Locknuts (105).
Then, slide the right Link Arm Cover (116)
over the M10 x 50mm Bolts (100) and the M10
Locknuts (105).
Repeat this step on the left side of the
elliptical.
4. Remove the two screws (A) and the shipping
bracket (B) from the right side of the Frame (1).
Discard the screws and the shipping bracket.
Tip: Avoid pinching the wires. Slide the upper
end of the Right Handrail (5) onto the right side
of the Upright (2).
Attach the Right Handrail (5) with two M8 x
45mm Bolts (130) and two M8 Locknuts (111);
make sure that the Locknuts are inside the
hexagonal holes, but do not tighten the Bolts
yet.
Then, insert the end of the Right Pulse Wire (80)
into the hole in the right side of the Upright (2)
and route it out of the top of the Upright.
Repeat this step on the left side of the
elliptical.
3
Avoid pinching
your fingers
9
43
15
4
4
2
Avoid pinching
the wires
A
B
1
9
8
116
100
Grease
105
80
130
Hexagonal
Holes
111
5