NordicTrack A.C.T. Elite User Manual page 12

9. Have a second person hold the Console (3) near
the Upright (2).
Plug the Upper Wire (81) into the large recepta-
cle on the back of the Console (3). Next, plug the
Right and Left Pulse Wires (80, 85) into the right
and left receptacles. The connectors on the
Wires should slide easily into the receptacles
and snap into place. If a connector does not
slide easily, turn it and try again. If you do not
insert the connectors properly, the Console
may become damaged.
Next, insert the excess wire into the Upright (2).
Tip: Avoid pinching the wires. Attach the
Console (3) to the Upright (2) with four M4 x
16mm Screws (67); start all the Screws, and
then tighten them.
10. Hold the Rear Upright Cover (21) against the
Console (3).
See step 8. Tighten the five M4 x 16mm Screws
(67).
Press the tabs on the Front Upright Cover (20)
into the Rear Upright Cover (21). Then, attach
the Front Upright Cover to the Upright (2) with an
M4 x 16mm Screw (67).
9
3
10
3
21
12
Avoid pinching
the wires
85
80
2
67
81
67
20
2