Table of Contents
Advertisement
6. COMPLETING
1. Make sure the wiring is safely inside the
outlet box as instructed in Step 5 -
Electrical Connections.
2. Attaching the Motor Assembly (Fig. 7)
Install the motor assembly over the
mounting plate and secure with the four
nuts and washers.
3. Attaching the Motor Housing (Fig. 8)
Raise the motor housing up against the
mounting bracket, the four supports inside
the housing should be placed against the
four studs on mounting bracket, twist the
housing clockwise until snug.
4. Blade Assembly & Installation (Fig. 9)
Using the supplied blade arm screws, attach
the blades to the blade arms. In some cases
the metal washer is permanently fixed to the
screw head. Ensure all screws are used for
each blade. Next attach the blade assembly
to the motor using the supplied screws. DO
NOT bend the blade arms when
installing the blades.
5. Attaching the Light Kit (Fig. 10)
Connect the two wiring plugs from the
motor assembly to the corresponding plugs
in the light kit. Attach the light kit to the
mounting plate by using the three (3)
screws provided that are preinstalled on the
mounting plate.
6. Attaching the light bulbs and glass
shade (Fig. 11)
Install 1 x 50W halogen bulb (included).
Install the glass shade assembly onto the
mounting plate with 3 screws provided. Be
sure to tighten all screws.
THE
Fig. 7
Washers
Nuts
Fig. 8
Studs
Motor
housing
Fig. 9
Blade arms
Screws
INSTALLATION
Fig. 10
Wire connector
Light kit
Fig. 11
Light kit
Glass shade
assembly
Screws
Fiber
washers
Blades
Mounting
ring
Screws
Bulb
Screws
Advertisement
Table of Contents
