Before Using - Mr. Coffee SRX20 Operating Instructions Manual

TO AUTOMATICALLY BREW AT PRE-SET TIME...
1. Follow steps # 1 through #5in "How to Brew Coffee".
2. Always slide the control switch to OFF and then to AUTO.
3. Brewing will begin at the time you have preset and the coffee
will remain hot in the decanter for 2 hours. If more keep warm
time is needed, turn the switch to ON for an additional 2 hour
keep warm time.
To Reset Auto Brew at Pre-Set Time.....
This coffeemaker will NOT automatically come on again the
next day if you leave the switch in the AUTO position after
its last use. This is a safety feature. Each time you choose to
use auto brew you must slide the switch to OFF and then to
AUTO.
To make sure Auto brew is set, check the auto off light. If the
light is off, auto brew is set. If it is on, slide the switch to OFF
and then to AUTO.
Before Using Your Mr. Coffee
Make sure your first cup of coffee is as good as can be by cleaning
your Mr. Coffee coffeemaker before you use it the first time. Just
follow these simple steps:
1. Wash the .decanter, lid and brew funnel in a mixture of mild
detergent and water. Rinse each thoroughly.
2. Set the clock. The clock on this model must be set first, before
the coffeemaker will operate. See instructions for setting the
clock.
3. Slide the brew funnel into place and then follow steps #4 through
#6 in the "HOW TO BREW COFFEE" section. This will clean
the inside of your coffeemaker.
4. When the brew cycle is finished, slide the control switch to
off. Discard the water in the decanter and rinse the decanter
and brew funnel.
Your coffeemaker is now ready to use.
IMPORTANT
_