Air Source; Symbol Definitions - Central Pneumatic 60314 Owner's Manual & Safety Instructions

Delayed or inadequate cleaning will permanently clog the Spray Gun.

Air Source

a. Never connect to an air source
that is capable of exceeding
200 psi. Over pressurizing the
tool may cause bursting,
abnormal operation, breakage of
the tool or serious injury to persons.
Use only clean, dry, regulated
compressed air at the rated pressure or
within the rated pressure range as marked on
the tool. Always verify prior to using the tool
that the air source has been adjusted to
the rated air pressure or within
the rated air-pressure range.
SAVE THESE INSTRUCTIONS.

Symbol Definitions

Symbol property or Statement
Pounds per square
pSI
inch of pressure
CFM
Cubic Feet per Minute flow
Cubic Feet per Minute flow
SCFM
at standard conditions
NpT
National pipe thread, tapered
Page 4
NOTICE
Clean the Spray Gun IMMEDIATELY after use.
For technical questions, please call 1-800-444-3353.
b. Never use oxygen, carbon dioxide,
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons.
Symbol property or Statement
NpS
National pipe thread, straight
WARNING marking concerning
Risk of Eye Injury.
Wear ANSI-approved
eye protection.
WARNING marking concerning
Risk of Respiratory Injury.
Wear NIOSH-approved respirator.
WARNING marking concerning
Risk of Explosion.
Item 60314