Service; Air Source - Central Pneumatic 66801 Set Up And Operating Instructions Manual

Industrial hvlp paint spray system with digital gauge
Table of Contents

Advertisement

formance. Follow instructions for
lubricating threaded connections and
changing accessories. Inspect tool
cords and air hoses periodically and,
if damaged, have them repaired by
an authorized technician. The handle
must be kept clean, dry, and free from
oil and grease at all times.
h.
disconnect air supply.
nect air hose when not in use, when
changing accessories, and during
maintenance.
i.
check for misalignment or bind-
ing of moving parts, breakage of
parts, and any other condition that
affects the tool's operation. If dam-
aged, have the tool serviced before
using. Many accidents are caused
by poorly maintained tools. There is a
risk of bursting if the tool is damaged.
j.
use only accessories that are
identified by the manufacturer for
the specific tool model. Use of an
accessory not intended for use with
the specific tool model, increases the
risk of injury to persons.

service

a.
Tool service must be performed
only by qualified repair personnel.
b.
when servicing a tool, use only
identical replacement parts. use
only authorized parts.
c.
use only the lubricants supplied
with the tool or specified by the
manufacturer.
For technical questions, please call 1-800-444-3353;
SKU 66801
Discon-
troubleshooting section near the end of manual.

air source

never connect to an air
a.
source that is capable of
exceeding 200 psi. Over
pressurizing the tool may
cause bursting, abnormal operation,
breakage of the tool or serious injury
to persons. Use only clean, dry,
regulated compressed air at the rated
pressure or within the rated pressure
range as marked on the tool. Always
verify prior to using the tool that the
air source has been adjusted to the
rated air pressure or within the rated
air-pressure range.
b.
Never use oxygen, carbon dioxide,
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons.
c.
use proper size and type exten-
sion cord. If an extension cord is re-
quired for the compressor, it must be
of the proper size and type to supply
the correct current to the compressor
without heating up. Otherwise, the
extension cord could melt and catch
fire, or cause electrical damage to the
compressor. Check your compres-
sor's manual for the appropriate size
cord.
saVe tHese
InstructIOns.
Page 5

Advertisement

Table of Contents
loading

Table of Contents