Sharp FO-90 Operation Manual page 54

• Repeat playback: To listen to your
messages again, press "7" and "#".
• Perform other operations: You
can enter any of the commands
described in the following section,
Other remote operations.
• Hang up: If you do not erase your
messages first, they will be saved
and any new messages will be
recorded after them. If you want the
FO-90 to resume normal operation
immediately, press "*" twice before
hanging up (in some cases,
particularly when the Transfer
function is used, the FO-90 may not
accept new calls for one or two
minutes after you hang up unless
you first press "*" twice).
Comments:
♦ When a remote command is accepted by the machine, you will hear
one beep. If an incorrect command is entered, you will hear four
beeps. In the latter case, re-enter the correct command.
♦ When entering a command, do not pause longer than 10 seconds
between each digit. If you do, a 4-beep error signal will be issued
and the digits entered up to that point will be disregarded. In this
case, re-enter the command from the beginning.
♦ If you make two errors (causing two 4-beep signals to be issued)
while entering your remote code number, the line will be discon-
nected. This prevents unauthorized people from attempting to guess
your remote code number.
♦ If you pause for longer than 10 seconds before entering a command,
you will be disconnected.
Remote Operations
7
53