Konica Minolta bizhub 363 Installation Manual page 7

<If A3 or Ledger paper is set in step 1>
5. Touch "Max Density Adjustment", select "A3
×
11 17 ", and press the start key.
A test pattern will then be produced on the A3
or Ledger paper.
6. Place the test pattern face down on the original
glass.
A1UDIXC019DA
7. Place about ten sheets of A3 or Ledger
paper on the test pattern placed on the original
glass.
Lower the cover.
A1UDIXC020DA
8. Press the start key.
The machine will start reading the test pattern.
9. When the machine completes reading the test
pattern, the "Gradation Adjust" screen will reap-
pear.
10. Confirm that "OK" is displayed for "Max Density
Adjustment" on the right top of the screen.
11. Touch "Gradation Adjustment", select "A3
/ 11 × 17 ", and press the start key.
A test pattern will then be produced on the
A3 or Ledger paper.
12. Place the test pattern face down on the original
glass.
13. Place about ten sheets of A3 or Ledger
paper on the test pattern placed on the original
glass.
Lower the cover.
14. Press the start key.
The machine will start reading the test pattern.
15. When the machine completes reading the test
pattern, the "Gradation Adjust" screen will reap-
pear.
16. Repeat steps from 11 through 14 to let the
machine read the test pattern two times.
17. Touch "END."
18. Touch "Exit" on the Service Mode screen.
/
<If A4 or Letter
5. Touch "Max Density Adjustment", select "A4
8 ½×11 ", and press the start key.
A test pattern will then be produced on the two
A4 or Letter
6. Place the test pattern face down on the original
glass.
A1UDIXC021DB
7. Place about ten sheets of A3
paper on the test pattern placed on the original
glass.
Lower the cover.
A1UDIXC020DA
8. Press the start key.
The machine will start reading the test pattern.
9. When the machine completes reading the test
pattern, the "Gradation Adjust" screen will reap-
pear.
10. Confirm that "OK" is displayed for "Max Density
Adjustment" on the right top of the screen.
E-7
paper is set in step 1> 11. Touch "Gradation Adjustment", select "A4
½×11
/ 8
A test pattern will then be produced on the A4
or Letter
papers. 12. Place the test pattern face down on the original
glass.
A1UDIXC022DA
13. Place about ten sheets of A3
or Ledger paper on the test pattern placed on the original
glass.
Lower the cover.
A1UDIXC020DA
14. Press the start key.
The machine will start reading the test pattern.
15. When the machine completes reading the test
pattern, the "Gradation Adjust" screen will reap-
pear.
16. Repeat steps from 11 through 14 to let the
machine read the test pattern two times.
17. Touch "END."
18. Touch "Exit" on the Service Mode screen.
/
", and press the start key.
paper.
A1UDIXC023DB
or Ledger
A1UDIXC020DA