Carburetor-Mark - AMF 1970 SKI-DADDLER SD15M21 A Parts And Service Manual

c
c
To Remove Carburetor-
Mark. VI and Mark. XX 295 only
(ESj
Always disconnect spark plug wires
before working on the engine or drive
elements.
• Loosen the throttle control cable adjustment
screw and release cable. On Mark VI only, re-
lease throttle control linkage at the carburetor.
• Release the throttle extension spring and hook
at the carburetor throttle control lever on the Mark
XX 295 only (see figure 8).
• Release the hose clamp and disconnect the im-
pulse line at the carburetor. Wipe up any spilled
gasoline immediately.
• Release the tank-to-carburetor gas line. Wipe
up any spilled gasoline immediately.
• Remove the locknuts securing the carburetor
to the carburetor adapter and r emove the car-
buretor.
NOTE: Do not damage gaskets when removing
carburetor.
• Installation is the reverse of removal. Adjust
carburetor as described in Carburetor Adjustment
procedures.
figure 8
9
ERVICE AND REPAIR
To
Remove Carburetor-
Mark. XX 399 and 439 only
~
Always disconnect spark plug wires
before working on the engine or drive
elements.
• Release the hose clamps and disconnect the
tank-to-carburetor gas line (figure 9) at the car-
buretor. Wipe up any spilled gasoline immediately.
• Remove the locknut securing the throttle arm
screw to the throttle arm.
figure
9
IMPORTANT: Before loosening the jam nuts, note
the space between the bottom jam nut and the throttle
control lever. This space must be maintained
during reassembly.
• Loosen the jam nuts between the throttle arm
and the throttle control lever and remove the
throttle rod screw.
• Remove the jam nut and lockwashers securing
the carburetor to the intake manifold and remove
the carburetor.
• Installation is the reverse of removal except
that the throttle rod screw must be inserted through
the throttle control lever and into the throttle arm