Table of Contents
Advertisement
ARIA SOHO IP Hardware Description and Installation Manual
TERMINAL CONNECTION AND WIRING METHOD
5.2 Cable Wiring
5.2.1 Wall Mount Wiring
To install wall mount wiring, perform the following Steps:
1. Ensure the BKSU and EKSU have been installed correctly.
2. Connect cables to the CO/STA port and the MOH/RS-232C ports as shown in Figure 5.2.1.
3. Connect the Power cord and the Battery cable.
4. Remove plastic filter pieces.
5. Tie all the cables and the Power cord (if desired) through the tie slot at the bottom-right side of the
KSUs using the tie cable provided.
6. Close the cover of the KSUs and close the cord cover.
FIGURE 5.2.1 WALL MOUNT WIRING
53
Issue 1
December, 2008
Hide quick links:
Advertisement
Table of Contents
