How To Ride Your Bike - Pulsar NS 150 User Manual

How to Ride Your Bike

1. Starting The Engine :
• Turn the fuel tap knob to '
position.
• Turn ignition switch key to ' ' position.
• Keep kill switch in '
• Confirm that transmission is in neutral /
press the clutch lever.
• If the engine is cold or when starting for
first time, use manual choke (
starting. Choke lever is located on LH side
of carburettor.
• Keep throttle completely closed, press
starter button,
• Release starter button as soon as engine
starts.
• When the engine is warmed up enough to
idle without using choke, return the manual
choke to OFF position.
Note : Do not let the engine idle longer than 3
minutes otherwise it will overheat.
Caution : Do not operate the starter
continuously for more than 5 seconds
otherwise battery would get discharged.
' or ' '
?
' position.
) for quick
Wait 15 sec. between each operation of the
starter which will facilitate battery to recover.
Note : The motorcycle is equipped with a starter
lockout switch. This switch ensures that engine
does not start if
However, the engine can be started in any
gear if the clutch lever is pressed.
Note : Incase of battery discharged condition,
vehicle can be started by pushing it.
2. Shifting Gears :
• Close throttle & depress the clutch.
• Shift into next higher or lower gear.
• Open the throttle and release the clutch
lever slowly and simultaneously.
3. Moving Off :
• Check that side stand is up / retracted.
• Depress the clutch lever.
• Shift into 1 gear. st
• Open the throttle and release the clutch
lever slowly and simultaneously.
• As the clutch starts to engage, open the
throttle a little more, giving the engine just
enough rpm to prevent it from stalling.
19
is in gear.
the transmission