Advertisement
REMOTE CONTROL BATTERY INSTALLATION
*J Remove the battery
compartment )id.
2
S)ide the batteries into the
compartment.
3
Replace the compart-
ment [id.
Note: For correct pofarity (+
and - terminal), be sure the
battery terminals are in
contact with the pins fn the
compartment.
The remote contro! unit can be used as wiretess or wired remote control.
US!MG THE REMOTE CONTROL UN)T (wireless)
Point the remote controi toward the front of the projector (Receiver window)
whenever pressing the buttons. Maximum operating range for the remote
controi is about 5m and 150 ° from the front of the projector.
US!NG THE REMOTE CONTROL UN!T (wired)
Connect a remote control cabte to RC jacks located on the remote controi
unit and the back of the projector.
To insure safe operation, p)ease observe the fo!towing precautions:
* Use (3) AA, UM3 or R06 type batteries.
* Change three batteries at the same time.
* Do not use a new battery with a used battery.
* Avoid contact with water.
* Do not drop the remote contro! unit.
Advertisement
