Operation; Heating / Clock Timer - Westfalia SVEN HEDIN Maintenance And Operating Manual

Hide thumbs Also See for SVEN HEDIN:
Table of Contents

Advertisement

1. Operation

1.1. Heating / Timer
Heater
Your vehicle is equipped with a fuel heater, Eberspächer type B2L
or D2L. The heater works independently from the engine, but is
operated from the fuel tank. The fuel consumption in continuous
operation is about 0.3 l / h. In normal operation the fuel
consumption is lower. The on, off and temperature switch for the
heating are on the control panel.
When the heating is on the inlet and outlet vents must be kept
open and clear. The fan can also be used without heating to
circulate air throughout the vehicle and draw fresh air in.
A = Dial (Temperature Control)
B = Red Control Light (Fault due to overheating)
C = Green 'On' Light
D = Switch – Heat / Air Conditioning – On/Off
Translated into English by
www.westfaliaLT.info - a useful site for enthusiasts and owners of VW Westfalia LT campers
www.westfaliaLT.info
– a useful website for VW Westfalia LT Camper enthusiasts.
Ventilation (with fresh air supply):
To Switch On
Press switch (D) to the left. The green light (C) will turn on and
the fan will begin to work.
To Switch Off:
Turn switch (D) to the middle setting. The green light (C) will turn
off.
Heating (with fresh air supply):
To Switch On
-
Turn dial (A) to Number 7
-
Press Switch (D) to the right
-
The green control light (C) will come on and the heating
will start
As soon as the temperature reaches the desired level, turn the dial
(A) back until the green light (C) goes darker. Doing this will set
the desired temperature. The space between each number on the
dial (A) corresponds to about 5° Celsius.
To Switch Off:
Turn switch (D) to the middle setting. The green light (C) will turn
off. The fan will continue running until the heater has cooled
down, and will then switch off automatically.
Normal Operation of the B2L (petrol)
The fuel pump is switched off. The heater operates without heat
but at full fan speed for about 3 minutes, then with a reduced fan
speed until the fan goes off and a new cycle begins. Once the

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents