Furniture Locks - Westfalia SVEN HEDIN Maintenance And Operating Manual

Changing the sliding seat bench into a bed:
With the seat in the living position use the lever to release the seat
cushion and pull forward. The seat back now moves automatically
to the horizontal position.
Changing the sliding seat bench from the bed into a seat in the
driving position:
Lift the horizontal cushion until the seat fittings lock in place then
press the seat cushion down and seat back will automatically go
into the right position.
Changing the rear seat bench into the bed:
Unlock the seat cushion, lift it and pull it forward. The seat back
goes automatically into the bed position and the seat cushion is
lowered.
Changing back the rear seat bench into the sitting position:
Lift the seat cushion and swing 90 to the rear until the seat fittings
lock in place. Fold down the high cushion and the seat cushion
must lock in place on the seat front panel.
Double bed in the high top
The front bed part is fixed. To construct the bed, open the flap
(right and left) and withdraw the extension evenly. Insert the
cushions.
Note: In the absence of child safety net (optional extra), small
children should sleep in the lower beds.
Attention: Whilst driving no one should be transported in the
upper bed.

1.10 Furniture Locks

Doors, flaps and drawers are fitted with safety handles so
they don't open whilst driving.
Translated into English by
www.westfaliaLT.info - a useful site for enthusiasts and owners of VW Westfalia LT campers
www.westfaliaLT.info – a useful website for VW Westfalia LT Camper enthusiasts.
To open pull the handle.
1.11 Information for the Winter
Before taking a winter vacation some things that you should pay
attention to:
During snowfall don't let snow build up around the roof vents.
Vents should not be covered by snow. Above all the flue in the
roof area near the hot water boiler and the exhaust pipe of the
heater should be kept free of snow. To prevent freezing of waste
water in waste water tank then a sufficient quantity of salt should
°
be added (up to -10 C) and ensure timely emptying.
The formation of condensation can largely be avoided by
appropriate use of heating and ventilation.
To ensure proper function of gas appliances (fridge, gas cooker,
hot water equipment) we recommend that at temperatures of +5
C and below the Eis-ex is switched on.
The vehicle should be parked safely so it doesn't slide in a thaw.
The hand brake should not be applied.
When the heater and hot water unit are switched on the vehicle is
suitable for use in temperatures of -10
°
drop in temperature to -15 C (eg: at night) harm to the water
supply system should not be feared. The rubber seals for the
opening windows and doors should occasionally be rubbed with
talcum powder.
When not used in winter if there is danger of frost then empty
the entire water and waste disposal system.
In order to achieve complete emptying, one should proceed as
described and additionally remove the hand shower hose through
the opening in the washbasin and lay it on the shower cabinet
floor.
°
°
C. Even if there is a short