Westfalia SVEN HEDIN Maintenance And Operating Manual page 13

Bringing into operation (220v)
Check if the voltage of the house or campsite mains connection is
within the required voltage. This can be found inside the fridge at
the top left. (The safety circuit breaker must be switched on)
1. Press in Button (C)
2. Turn the combined electric / gas thermostat dial (B) clockwise
to the max setting.
3. When not in use, switch off button (C) by using button (D) or
(E).
Bringing into operation (12V)
When using 12V, your fridge is protected by the general electrical
circuitry of your vehicle. To prevent your vehicle's battery from
draining, a measure has been built into the 12V circuitry to ensure
that the fridge can only be used when the vehicle's engine is
running.
When the fridge is running on 12V it cannot be controlled by the
thermostat.
1) Press in button (D) before driving off.
2) When not in use, switch off button (D) by using buttons (C) or
(E).
Translated into English by
www.westfaliaLT.info - a useful site for enthusiasts and owners of VW Westfalia LT campers
www.westfaliaLT.info – a useful website for VW Westfalia LT Camper enthusiasts.
Bringing into operation (LPG)
The fridge is designed for use with Propane or Butane gas only.
Natural gas or city gas must not be used.
1. Open the valves (main valve of the gas tank, and quick release
valve in the kitchen cupboard)
2. Turn the thermostat knob (B) clockwise to the max setting.
3. Press in button (E). Straight after pressing the button, the
electronic gas ignition will switch on, the red signal light (F) will
light up.
4. Press button (A) in and keep it pressed in. After 20-30 seconds,
the burner will automatically ignite. As soon as the flame lights,
the ignition will stop, and the red signal light (F) will go out. Keep
the button (A) pressed in for another 15-20 seconds, then the
thermo-electric ignition from the LPG tank will stay open.
You can see the progress of the ignition steps by flashing light (F).
The use of the burner flame is shown by control light (G) (see
below) as long as switch (A) on the cooker display is switched on.
Should there be a cause (other than the LPG tank being empty) for
the gas flame to go out, it will ignite again automatically. If it does
not ignite due to a defect, the protection mechanisms will activate
and will automatically shut off the LPG supply.
5. When not in use or if the fridge has a problem using gas, stop
the gas supply to the fridge & switch off button (E) by using
button (C) or (D).