Water Supply / Warm Water Boiler - Westfalia SVEN HEDIN Maintenance And Operating Manual

1.4.1 Warm Water Boiler
The warm water heater is installed in the roof and is powered by gas
(propane / butane). The water temperature is controlled and regulated by
an electronic ignition.
To avoid damage to the hot water heater only operate in the filled state.
After emptying the hot water system check that the safety valve has been
closed (the red lever switch (A) should not be in high position.)
1) To fill boiler, turn on a warm water tap. The pump switches on
and water comes from the tap. Turn off the warm water tap when
there are no more air bubbles in the water.
2) Open the valves (valve on gas tank, main valve in gas supply and
the quick closing valve for the hot water boiler).
3) Switch on via the switch on the display panel and the green LED
should come on. The yellow LED is not used and does not light.
4) With the rotary knob you can set the water temperature between
30 -75° Celsius. The electronics will switch the burner on and off
as required.
Attention! The manufacturer is not liable for frost damage. Please
note the information for winter use (section 1.11).
Translated into English by
www.westfaliaLT.info - a useful site for enthusiasts and owners of VW Westfalia LT campers
www.westfaliaLT.info – a useful website for VW Westfalia LT Camper enthusiasts.
Warm Water Boiler / Emptying
1) Remove the 10 amp fuse (under the tap symbol) from the display
panel.
2) Turn on the mixer tap and open the drain plug on the sink in the
shower room.
3) Open the emptying access valves on both fresh and waste water
tanks.
4) Open the safety valve (A) by raising the red lever that is located
inside the rear bench seat. The water drains through the bottom
outlet.
When you drain the water system observe any environmental
laws. On the campsite observe the rules and regulations.