Connecting Cables - Huawei AP6010DN-AGN Quick Start Manual

Connecting Cables

Item
No.
Power
1
adapter 12 V
DC
Network
2
cable
Requirements for making a network cable:
● Cut the cable of proper length based on the distance between the AP and the PSE device, peel the insulation on
both ends of the network cable, and crimp the wires to RJ45 connectors.
● Connect RT45 connectors to the network cable tester to test cable connectivity. The following shows the pin
assignment.
X1 Pin
1
2
3
4
5
6
7
8
CAUTION
● The service network cable cannot be connected to the console port. Otherwise, the AP6010DN may be damaged
when using PoE power supply.
● Before connecting the cable to the AP, coil the cable around the wall-mounting bracket first. This prevents the cable
from being bent.
● The AP6010DN supports PoE power supply and DC power supply.
● When both the PoE power supply and DC power supply are available, the DC power
supply is used.
● When DC power supply is used, use the specified power adapter; otherwise, the device may
be damaged.
If the AP needs to connect to the Ethernet, ensure that the Ethernet cable is working
properly. If the Ethernet cable is not working properly, for example, RJ45 connectors are short-
circuited, the AP may fail to be powered on or fail to work. Before connecting an Ethernet cable
to the AP, use the cable test tool to check whether the cable is qualified. If the cable is
unqualified, replace it.
Description
Wire Color
White and orange
Orange
White and green
Blue
White and blue
Green
White and brown
Brown
6
Connect the network cable to the AP
X2 Pin
1
2
3
4
5
6
7
8