Busy Signal; Receiving Intercom Calls - Cardo Systems PACKTALK User Manual

5.2c CLICK-TO-LINK (CTL) INTERCOM MODE
Click-to-Link is a spontaneous way to instantly initiate 1-on-1 intercom calls
with other riders near you, without being paired. Think of it as a private channel
that you can set up on-the-go with other riders that you see along the way.
Click-to-Link can be disabled effectively blocking any attempt by a third party to send a
CTL request to you.
Start a CTL call request
(search lasts up to 10 sec.)
End a CTL call /
Cancel a CTL call request
Accept a CTL call
Reject a CTL call
Enable / Disable CTL
(Enabled by default)
If other riders are nearby, your next Click-to-Link call may randomly connect to any of them.

5.3 BUSY SIGNAL

When attempting to establish an Intercom call with another device that is already busy,
a "busy" signal will be heard. The scala rider is busy while on a phone call, intercom call
with Channels "A" and "B", "1+8" intercom call or CTL call.

5.4 RECEIVING INTERCOM CALLS

If a paired unit tries calling you via Intercom, the call will begin almost instantly.
|
24
v
In Standby, press for 2 seconds
v
Tap
When hearing the CTL ringtone: Tap
to answer by VOX
While hearing the CTL ringtone, remain silent until the ring tone
v
stops, or press for 2 seconds
See section 3
v
or say any word loudly