(For general system preparation, see the O-Line preliminary Installation Guide)
General
Your O-Line is delivered in blocks of 4 modules ready wired in parallel. These four‐module blocks may be
separated into smaller blocks or individual modules, linked and paralleled to other blocks or modules using
short link wires ‐ or series connected to other blocks or modules using the series Connector pcb supplied with
each four‐module block (see illustration below).
The Connector pcb also provides an input termination.
This allows the installer to build an array of appropriate length (we recommend 6% of each plane to be covered
for good spectral balance) with electrical characteristics best suited to the Martin Audio power amplifier
chosen.
Powering your O-Line™
1