Fueling; Fitting The Full Harness - Stihl FS 460 C-M Instruction Manual

Fueling

Preparations
WARNING
When fueling on a slope, always position
the machine so that the fuel filler cap is
facing uphill.
On level ground, position the
N
machine so that the fuel filler cap is
facing up.
Before fueling, clean the fuel filler
N
cap and the area around it to ensure
that no dirt falls into the tank.
Always thoroughly shake the mixture in
the canister before fueling your
machine.
WARNING
In order to reduce the risk of fire and
personal injury from escaping gas vapor
and fumes, remove the fuel filler cap
carefully so as to allow any pressure
build-up in the tank to release slowly.
FS 460 C-M, FS 460 C-M L, FS 490 C-M, FS 490 C-M L
Opening the fuel filler cap
Turn the fuel filler cap
N
counterclockwise until it can be
removed from the tank opening.
Remove the fuel filler cap.
N
Refueling
Take care not to spill fuel while fueling
and do not overfill the tank.
Closing the fuel filler cap
Position fuel filler cap.
N
Turn the fuel filler cap clockwise as
N
far as it will go and tighten it as
securely as possible by hand.

Fitting the Full Harness

Fitting the full harness is described in
detail in the instruction sheet supplied.
2
3
Put on the full harness (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Attach the spring hook to the
N
machine's perforated strip (3).
Find the right attachment point for the
cutting attachment you are using – see
"Balancing the Brushcutter".
English
1
29