Advertisement
Power up your Mako by plugging the power adaptor into the DC power socket at the rear. Now
observe that status of the front panel LEDs.
There are ten "LED" indicators, for now we only need be concerned with four of these:
•
POWER
•
TX/RX
•
LINK
READY
•
When turning on for the first time, your Mako will go through a self-configuration process in the
sequence detailed below.
Step
1.
Your Mako will establish a connection with
the local exchange and the LINK LED will
change from flashing to solid when this is
complete.
2.
After a connection is established with the
exchange the Mako will connect directly to the
CMS
to download its configuration. The DSL's
TX/RX LED will flash during this download to
indicate activity.
3.
Once the profile has been downloaded from
the CMS, the READY LED will illuminate,
indicating that your Mako finished its
configuration process and is ready to be used.
During Step 2 it's vital that this download is completed before power is removed from you Mako.
If power is removed during this process, you Mako will have to be returned to you reseller for
reconfiguration. The POWER LED should be on while download of the secure profile takes place.
Note: Allow up to ten minutes for the LINK LED to illuminate and your Mako to be ready for use.
DO NOT unplug the power for any reason after first powering up your MAKO for at least 20min
after the initial power up.
Mako 6500-A2 and A2/3G Product Handbook v.1.2
Power
On
On
On
Page 9 of 24
LED and status
TX/RX
LINK
Ready
Flash
|
Off
v
On
Flash
On
N/A
On
Off
Off
On
Advertisement
