Advertisement
These LEDs will only be used for diagnostics and configuration. During normal operation you
needn't worry about the status of these LEDs.
Key
Name
1
Power
2
TX/RX
3
LINK
4
TX/RX
5
LAN 1
6
TX/RX
7
LAN 2
8
WAN 1
READY
9
(ADSL Only)
WAN2
9
(3G Only)
10
ERROR
Refer to Chapter 5.2 Diagnosing the Mako 6086-A2 Panel Indicators on page 14 below for details
on error messages relayed through these Panel LEDs.
When the LINK, WAN and READY LEDs are glowing, your Mako is connected to the Internet and
ready for use.
Mako 6500-A2 and A2/3G Product Handbook v.1.2
On
Indicates that the Mako is
connected to a power
source
An active and established
DSL connection to your
service provider
Link is present with LAN 1
Link is present with LAN 2
The Mako has established
a connection to your ISP
All Mako services are
ready to operate
The Mako has established
a connection to your ISP
and the Mako is ready
An error condition exists
Page 10 of 24
Off
Mako is off
Internet data activity
No DSL
A DSL connection to
connection or
your service provider
service provider
during configuration
outage
Data activity with LAN 1
Data activity with LAN 2
DSL isn't
PPP is connecting. Slow
connected
flash – DSL is training
Dial tone established.
Mobile data not
Slow flash – unable to
connected
establish a dial tone.
Flashing
Advertisement
