3.
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pins labeled "Intruder" are shorted with a jumper cap. Remove
the jumper caps only when you intend to use the chassis intrusion detection
feature.
N3150I-C / N3050I-C Chassis intrusion connector
4.
Display panel backlight power selector (3-pin BLKT_PWR_SEL)
N3150I-C / N3050I-C Display panel
backlight power selection
Pins
1-2 (Default)
2-3
ASUS N3150I-C / N3050I-C
CHASSIS
PIN 1
BLKT_PWR_SEL
1 2
2 3
12V
5V
(Default)
Setting
12V
5V
1-9