Optical In (Tv Audio Connection); Sub Out (Bxa100 Subwoofer Amp Connection); L- L+ R- R+ (Speaker Connections); Line In (Auxiliary Audio Source) - Xpress D2.1 User Manual

Connections
NOTE: Do not connect the AC power cord or turn the amp on until all connections have been
made and confirmed. Making connections with the power on can result in...well...undesir-
able circumstances...that may not be covered under the factory warranty.

OPTICAL IN (TV AUDIO CONNECTION)

1. Using a Digital Optical Audio cable, connect the Digital Optical Audio OUT on the TV (or
other source) to the Optical IN on the D2.1. To select this input, press IN 2 on the D2.1 IR
Remote.

SUB OUT (BXA100 SUBWOOFER AMP CONNECTION)

1. Using a mono RCA-RCA cable with gold ends, connect the Sub OUT on the D2.1 to the Sub
IN on the BXA100 subwoofer amp , a powered sub or other subwoofer amplifier.

L- L+ R- R+ (SPEAKER CONNECTIONS)

1. Use16AWG (min) 2-conductor stranded speaker wire for speaker connection
2. Strip approximately 1/2 to 3/4 of an inch off the ends and twist the strands together so
there are no loose ends that can cause shorts.
3. While observing proper wire polarity, insert the stripped and twisted ends of the speaker
wire into the appropriate + and - terminals for the left and right speakers.
4. Tighten the terminal screws.
5. Confirm connection and polarity.
6. Connect the speaker wires to the appropriate + and - terminals on the left and right speak-
ers.
7. Confirm connection and polarity.

LINE IN (AUXILIARY AUDIO SOURCE)

1. Using a stereo RCA-RCA patch cable connect the L&R line level audio OUTs on a Bluetooth
audio receiver or other source to the L&R Line IN on the D2.1. To select this input, press IN
1 on the D2.1 IR Remote.
RECEIVER IN (BLUETOOTH AUDIO STREAMING & AMPLIFIER SETUP)
1. Using a Cat5 patch cable with RJ45 connectors, connect the output of the Xpress
Bluetooth Module to the Receiver IN port on the D2.1. For streaming audio, see section
'Operation' for information on pairing a Bluetooth device. For information regarding the
setup App, please visit www.bealexpress.com for additional information.

AC POWER TERMINAL (100-240V-50/60Hz 2.5A)

1. After all connections have been made connect the supplied AC Power Cord to an un-
switched AC power outlet. Automatically selects AC power mode (110VAC/220VAC) when
connected to AC power.
NOTE: Do not connect the AC power cord or turn the amp on until all connections have been
made and confirmed. Making connections with the power on can result in...well...undesir-
able circumstances...that may not be covered under the factory warranty.
11