Related Manuals for Xpress A100
Summary of Contents for Xpress A100
-
Page 1: User Guide
A100 Class D 100W Subwoofer Amplifier User Guide VOLUME PHASE CROSSOVER POWER BOOST... -
Page 2: Important Safety Instructions
Important Safety Instructions RISK OF ELECTRIC SHOCK DO NOT OPEN APPLICABLE FOR USA, CANADA OR WHERE RISQUE DE CHOQUE ÉLECTRIQUE N'OUVREZ PAS APPROVED FOR USAGE CAUTION: TO PREVENT ELECTRIC SHOCK, CAUTION: To reduce the risk of electric shock, do not remove cover (or back). MATCH WIDE BLADE PLUG TO WIDE SLOT, No user-serviceable parts inside. -
Page 3: Table Of Contents
Table of Contents Important Safety Instructions .................2 Table of Contents ....................3 Introduction .......................4 Features ......................5 What’s Included ....................5 Front Panel Features ..................6 Rear Panel Features ..................7 Side Panel Vents ....................8 Installation ......................9 Connections ....................10 Operation ......................12 Specifications ....................13 Limited Warranty ................... -
Page 4: Introduction
Introduction Congratulations and thank you for purchasing the Xpress A100 Subwoofer Amplifier! The A100 may be small in physical appearance but its got all the muscle you need to drive even the most demanding subwoofers to house thumping levels. The A100 is a Class D 100 Watts amplifier that when properly installed, runs cool under almost any load. -
Page 5: Features
• Adjustable Subwoofer Crossover Frequency • Adjustable Phase Settings • 40Hz 6dB Boost Switch • Audio Sensing • 12/24VDC On/Off Trigger Input • 110/220V Switchable What’s Included 1 - A100 Amplifier 1 - AC Power Cord 1 - User Guide... -
Page 6: Front Panel Features
CROSSOVER POWER BOOST 1. POWER LED - One, green LED. Green LED illuminates when the A100 is connected to AC power and turned ON. 2. PHASE - The Phase setting allows compensation for subwoofer location relative to the main speakers. Adjust the Phase setting to the point of highest sub audio output. -
Page 7: Rear Panel Features
FUSE:110-120V,T2AL/250V FUSE:220-240V,T1AL/250V 1. INPUT - Two, RCA jacks. Stereo or mono audio sensing line level audio input. A100 will turn ON when a line level audio signal is present on either jack. Amp will turn OFF after 15 minutes of no audio signal. -
Page 8: Side Panel Vents
Side Panel Vents Even though the A100 will typical run cool, the side vents allow air to circulate through the chassis allowing optimum performance, and besides...they just look cool...get it...air vents... look cool...never mind... One serious item...please be sure to not block the vents with wires or other objects that will block the free flow of air through the amp. -
Page 9: Installation
Installation SHELF MOUNT The A100 can be conveniently mounted on a shelf top as shown. Leave room for wires. Allow adequate space for airflow. Do not set objects on top of the amp. A100 VOLUME PHASE CROSSOVER POWER Shelf... -
Page 10: Connections
All connections are conveniently placed on the rear panel for sane wire management, convenient connections and simple service. The illustration shows the A100 in a typical home entertainment system driving an in ceiling subwoofer for TV audio with stereo in ceiling speakers. - Page 11 1. Using a stereo or mono RCA-RCA cable with gold ends, connect the LFE OUT, Sub OUT, or other line level audio OUT on an amplifier, surround receiver or other audio preamp to the Input on the A100. SPEAKER OUT (A100) 1.
-
Page 12: Operation
Operation Once installed and setup, the A100 doesn’t typically need a whole lot of attention. But just in case you need to tweak something, here’s what you’ll want to do... ON/OFF The A100 is auto-sensing, so typically once the system is installed and setup, the power will automatically turn ON with the presence of an audio signal on either of the L &... -
Page 13: Specifications
Specifications AUDIO Maximum Output Power ....................70W/8Ω; 100W/4Ω THD ..................................1% Frequency Response ....................40Hz-160Hz +/-3dB Signal to Noise ............................95dB Input Sensitivity ............................. 200mV Crossover ............................40-160Hz Phase................................. 0-180° GENERAL Trigger Input ........................+12VDC to +24VDC Line Voltage Range ....................110-120/220-240 VAC Standby Power ............................ -
Page 14: Limited Warranty
This warranty shall not apply to products which have been abused, modified, disassembled, or repaired by anyone other than Xpress or one of its appointed service centers. Products to be repaired under this warranty must be returned to the factory or designated service center with all transportation and insurance charges pre- paid. -
Page 15: Notes
Notes... - Page 16 Beale Xpress 122 Gayoso Street, Suite 101 Memphis, TN 38103 Phone: 844.489.2700 Fax: 901.205.0900 www.bealexpress.com ©2015 Beale Street Audio A100UG073115 Rev 1...