American Audio 14MXR User Manual And Reference Manual page 12

14MXR
15. CUE, SYNC, PITCH BEND, & PLAY/PAUSE (MIDI) -
CUE 1, 2, & 3 - These buttons will set or trigger hot cue 1, 2, or 3.
DELETING HOT CUE POINTS - If a hot cue point is set, it is indicated by a lit Cue button LED. If
you wish to delete a hot cue point, press the Shift button. The shift button LED will flash along with
the Cue LEDs. Press the Cue button that contains the hot cue you wish to delete. After,
press the Shift button again to disable the soft shift.
PITCH BEND - To perform temporary pitch bends in Virtual DJ, hold the Shift button and Cue 1 to
slow the track. To speed up the track hold the Shift button and press the Sync button. To reset
the pitch, hold the Shift button and press Cue 3.
SYNC - Will sync the selected deck to the opposite deck or master deck/tempo.
CUE - When the deck is playing, pressing this button will return to the 1st cue point. If the deck is
paused, pressing Cue will set a new cue point.
16. MICROPHONE SECTION -
MIC 1 & 2 GAIN CONTROL - These knobs individually control the output volume of MICRO-
PHONES 1 & 2. However, master volume is controlled by the MASTER VOLUME CONTROL (3).
MICROPHONE 1 & 2 TREBLE CONTROL - This knob is used to adjust the treble levels of the
Microphone with a maximum signal gain of 12dB or maximum signal decrease of -12dB. Turning the
knob in a counter-clockwise direction will decrease the amount of treble applied to the microphone
signal, turning the knob in a clockwise direction will increase the amount of treble applied to micro-
phone signal.
MICROPHONE 1 & 2 MIDRANGE CONTROL - This knob is used to adjust the midrange levels of
the Microphone with a maximum signal gain of 12dB or maximum signal decrease of -12dB. Turning
the knob in a counter-clockwise direction will decrease the amount of treble applied to the micro-
phone signal, turning the knob in a clockwise direction will increase the amount of treble applied to
microphone signal.
MICROPHONE 1 & 2 BASS CONTROL - This knob is used to adjust the low frequency levels of
the microphone with a maximum signal gain of 12dB or maximum signal decrease of -12dB. Turning
the knob in a counter-clockwise direction will decrease the amount of bass applied to the microphone
signal, turning the knob in a clockwise direction will increase the amount of bass applied to micro-
phone signal.
TALKOVER CONTROL - This function decreases all signal output except the microphone signal.
The amount of decrease is preset to -14dB and is not user selectable.
American Audio - www.americanaudio.us - 14MXR Instruction Manual Page 12
© ®
CONTROLS AND FUNCTIONS cont.