Control Panel; Dryer Components; Top Cover - GE DCVH480EK Technical Service Manual

WARNING: Sharp edges may be exposed when
servicing the dryer. Use caution to avoid injury.
Wear Kevlar gloves or equivalent protection.

Top Cover

Removal of the top cover provides access to the
control panel and front panel. Two Phillips-head
screws, are located at the rear of the top cover. After
removal of the screws, the cover can then be slid
rearward 1 inch, then lifted to disengage it from the
cabinet.
Top View

Control Panel

The control panel is held in place with 4 Phillips-
head screws and 4 tabs. Two tabs engage the front
brace and 2 tabs engage the cabinet front.
To remove the control panel:
1. Remove the top panel. (See
2. Remove the 2 Phillips-head screws that attach
the top of the control panel to the front brace.

Dryer Components

.)
Top Cover
– 22 –
3. Pull the top of the panel up and out from the top
brace, then lift the panel off of the cabinet front.
Cabinet Front
4. Disconnect the control panel wires and
harnesses.
Top Brace