Primary Co2 Regulator; Secondary Co2 Regulators; Water Flow Rate; Water--To--Syrup ' ' Ratio' 'Of Dispensed Product - Cornelius AURORA 10,000 PLUS Installation Manual

Cooling unit
Table of Contents

Advertisement

PRIMARY CO
REGULATOR
2
Adjust primary CO
regulator on CO
2
24--psi higher than highest setting required by the secondary CO
screw locknut. Turn adjusting screw to the right (clockwise) until regulator gage registers nominal 120--psi, then
tighten adjusting screw locknut.
SECONDARY CO
REGULATORS
2
Carbonator Secondary CO
Adjust carbonator secondary CO
ing screw locknut. Turn adjusting screw to the right (clockwise) until regulator gage registers nominal 90--psi,
then tighten adjusting screw locknut. CO
Sugar Syrup Soft Drink Tanks CO
Adjust sugar syrup soft drink tanks secondary CO
10--feet in length plus one pound for each additional length of 10--feet, plus one pound for each 2--feet of vertical
lift. For example: if syrup line total length is 30--feet and total vertical lift is 6--feet, then 40--psig + 2--psig
(1--pound for every 10--feet of length over 10--feet which is 20--feet) + 3--psig (1--pound for every 2--feet of verti-
cal lift which is 6--feet); total equals 40 + 2 + 3 = 45--psig CO
Low--Calorie (diet) Syrup Soft Drink Tank CO
Adjust low--calorie (diet) soft drink tank secondary CO
10--psig for syrup lines up to 30--feet in length. Syrup lines longer than 30--feet in length may require a slightly
higher CO
regulator setting to 12--psig maximum. Excessive CO
2
bonation resulting in foam.

WATER FLOW RATE

Refer to Installation Instructions provided with dispensing station for dispensing valve water flow rate adjust-
ment instructions.
WATER- -TO- -SYRUP ' ' RATIO' 'OF DISPENSED PRODUCT
Adjust dispensing station dispensing valves for Water--to--Syrup ' ' Ratio' 'of dispensed product as instructed in
dispensing station Installation Instructions.

CLEANING AND SANITIZING

DAILY CLEANING OF UNIT

1. Remove cup rest from the drip tray.
2. Wash drip tray in place on the Unit, then rinse drip tray with hot water allowing water to drain out through
the drain hose.
1593
cylinder (see FIGURE 2) to a minimum nominal setting of 120--psi or
2
Regulator.
2
regulator (see FIGURE 2) to a nominal 90--psi. Loosen CO
2
PRESSURE TO CARBONATOR MUST NOT EXCEED 125--PSIG.
2
Regulator.
2
2
Regulator.
2
regulators. Loosen CO
2
regulator (see FIGURE 2) at 40--psig for syrup lines up to
regulator setting.
2
regulator (see FIGURE 2) for low--calorie drink at
2
pressure may cause low--calorie syrup car-
2
26
regulator adjusting
2
regulator adjust-
2

Advertisement

Table of Contents
loading

Table of Contents