K1 Board; S Board - Sony FWD-32LX1R Service Manual

1-4-4. K1 Board

Removal
1. Remove the cabinet assembly.
(Refer to Section 1-3-1.)
2. Remove the shield cover G and two arms.
(Refer to steps 2 and 3 of Section 1-4.)
3. Disconnect the three harnesses from the connectors
(CN5000 - CN5002) on the K1 board.
4. Remove the four screws, then remove the K1 board.
Harness
CN5002
K1 board
CN5000
Conductive cushion
Installation
5. Install the K1 board in the reverse order of steps 3 and
4.
6. Reassemble this unit in the reverse order of steps 1 and
2.
1-8

1-4-5. S Board

Removal
1. Remove the cabinet assembly.
(Refer to Section 1-3-1.)
2. Remove the shield cover G and two arms.
(Refer to steps 2 and 3 of Section 1-4.)
3. Disconnect the harness from the connector (CN9400)
on the S board.
4. Remove the screw, then remove the S board.
Harnesses
BVST
CN9400
3 x 6
CN5001
Installation
5. Install the S board in the reverse order of steps 3 and 4.
6. Reassemble this unit in the reverse order of steps 1 and
2.
Harness
BVST
3 x 6
S board
Conductive cushion
FWD-32LX1R