Sanyo DC-TS765KR Service Manual page 11

SERVICE MODE
4. Setting REGION code
4.1 While a highlighted indicator is displayed on the right side
of the Region denotation, push ENT button on the remote
controller. With each push the indicator will advance as
shown below.
1 -> 2 -> 3 -> 4 -> 5 -> 6
4.2 Specify the number of the model in accordance with the
Market/Region Setup Table above.
4.3 Once the desired number is displayed, push p button to
move the highlighted indicator to Exit area.
5. Saving settings
5.1 Make sure that the Market and Region settings are properly
set.
(If any of the settings are incorrect, you can make a change
by moving the indicator using p button, and following
procedures 3 and 4 above. )
5.2 After ensuring that the settings are all correct, push ENT
button while the indicator is on Exit area. The settings are
now saved.
6. Finishing settings
6.1 After a few seconds, the Internal Setup screen disappears,
and then the Service Mode screen is displayed again for
three seconds as shown on the right.
You should check the settings.
Backend version
Brand (S : SANYO , F : FISHER)
Version ( 2 0 0 2 , 12 , 25)
Sub Version (A,B,......Z)
Region ( 0 : Region undefined
1 ~ 6 : Region defined )
6.2 Power OFF.
S 21225 A 1
- 11 -
Internal Setup
00
M a r k e t
1
1
Region
00-WM 01-SFC 02-UK 03-XE
S18
05-SS 06-PA 07-AU 08-CN 09-JP
Internal Setup
00
M a r k e t
1
Region
00-WM 01-SFC 02-UK 03-XE
S18
05-SS 06-PA 07-AU 08-CN 09-JP
Region 1 M a r k e t
BackendVersion S21225A1
LoaderVersion
Exit
04-
(Reference figure)
Exit
04-
(Reference figure)
W M
55 50 05
Value
(Reference figure)