Table of Contents
Advertisement
A P P E N D I X C
Troubleshooting
This section describes troubleshooting tips for the most common
problems.
Auto-discovery is not detecting simplefi
If your PC cannot find s i m p l e f i during discovery, press the
button on the back of your s i m p l e f i. If this does not fix your
problem, you may need to reset your s i m p l e f i to factory default
settings. This may be necessary for a number of reasons,
including:
• You changed your network connections and/or IP addresses,
and need to connect (re-discover) simplefi.
• You purchased a new PC and want to install SimpleServe on
your new PC.
• You re f o rmatted your hard disk and reinstalled Windows. Yo u ' l l
need to re-install SimpleServe as well.
The procedure to reset s i m p l e f i depends on whether simplefi is
connected to SimpleServe, as described below.
To reset simplefi while simplefi is connected to SimpleServe
If s i m p l e f i displays channel, playlist and track information, press
the
Menu
button on your remote control. s i m p l e f i displays the
headphone volume configuration screen. Press the
Right
button on the remote control. s i m p l e f i prompts you to
reconfigure s i m p l e f i. Use the
Press the
Select
button on the remote control to reset s i m p l e f i.
s i m p l e f i indicates it is reset by displaying:
Looking for PC...
simplefi is in
discovery mode.
APPENDIX C, TROUBLESHOOTING
T R O U B L E S H O OTING
Navigate Dn
button to select Yes.
Reset
Navigate
63
Advertisement
Table of Contents
