Wire Wallplate Or Subbase - Honeywell Q682B Manual

Fig. 3—Leveling methods for wallplate or
subbase.
PLUMB
LINE
PLUMB
BOB OR
WEIGHT
Outlet Box Mounting (Fig. 4)
Use a horizontally mounted outlet box if possible. If a
vertical outlet box is used, mount the wallplate or subbase on
a 193121A (beige) or 202689A (white) Cover Plate Assem-
bly (ordered separately). Follow the instructions provided
with the cover plate assembly.
Align wallplate or subbase mounting holes on the outlet
box and loosely fasten with two screws.
Carefully level the wallplate or subbase (Fig. 3) and
firmly tighten the screws.
Fig. 4—Mounting wallplate or subbase on horizontal outlet box.
EXISTING
HORIZONTAL
OUTLET BOX
R
G
FAN
ON AUTO
SPIRIT LEVEL
O
B
R
W
G
Y
FAN
ON AUTO HEAT OFF
O
B
W
HEATING/
COOLING
SUBBASE
Y
COOL
HEAT OFF
M1553A
1 NOT INCLUDED WITH UNIT.
2 ACCESSORY PARTS AVAILABLE.

WIRE WALLPLATE OR SUBBASE

Follow the instructions provided by the heating, cooling
or heating-cooling equipment manufacturer. If not avail-
able, refer to Typical Wiring Diagrams section at the end of
this publication.
Disconnect power supply before making wiring connec-
tions to prevent electrical shock or equipment damage.
NOTE: All wiring must comply with local electrical codes
and ordinances.
This thermostat clock can be powered by 24 Vac trans-
former with battery backup, 24 Vac transformer only or bat-
tery only, or through the control system. See Figs. 15 through
19 for hookup diagrams of typical powering applications.
Wallplate (Heating or Cooling Systems)
COOL
Refer to Fig. 5 and strip thermostat wire insulation as
M1555
necessary.
For heating-only systems, connect wires to R, W and C (if
applicable) terminals. For cooling-only systems, connect
wires R, Y and C (if applicable) terminals. Firmly tighten
screws. See Fig. 20.
Push excess wire back into the wall.
Plug the hole in the wall with nonhardening caulk, putty,
or nonflammable insulation to prevent drafts from affecting
thermostat operation.
Subbase (Heating-Cooling Systems)
Refer to Fig. 5 and strip the thermostat wire insulation as
necessary.
VERTICAL
OUTLET
1
BOX
2
ADAPTER
RING
SUBBASE OR
WALLPLATE
MOUNTING
SCREWS (2)
3
EXISTING
HORIZONTAL
OUTLET BOX
R
W
COVER
PLATE
2
O
B
W
R
Y
G
M1554A
WALLPLATE
M856
69-0431—2