Control Lock - GE PCB975 Owner's Manual

Using the clock, kitchen timer and control lock.
(on some models)
(on some models)
Make sure the clock is set to the
correct time of day.
(on some models)
(on some models)
The Kitchen Timer is in hours and
minutes.
The Kitchen Timer does not control
oven operations. The maximum
setting on the Kitchen Timer is
9 hours and 59 minutes.
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
To Set the Kitchen Timer
Touch the TIMER/CLOCK or TIMER
pad (depending on model).
Touch the number pads until the
amount of time you want shows
in the display. For example, to set
2 hours and 45 minutes, touch 2, 4
and 5 in that order. If you make a
mistake touch the TIMER/CLOCK or
TIMER pad (depending on model)
and begin again.
Touch the START pad.
To Reset the Kitchen Timer
If the display is still showing the
time remaining, you may change it by
touching the TIMER/CLOCK or TIMER pad
(depending on model), then touch the
number pads until the time you want
appears in the display.
To Cancel the Kitchen Timer
Touch the TIMER/CLOCK or TIMER pad
(depending on model) twice.

Control Lock

(on some models)
Your control will allow you to lock out the touch
pads and the cooktop so they cannot be activated
when touched.
To lock/unlock the controls and cooktop:
Touch and hold the CONTROL LOCK
pad for 3 seconds.
The oven display will show " Oven
controls and burners locked " for
several seconds, then " Range
Locked ."
www.GEAppliances.ca
On some models, touch the
TIMER/CLOCK pad and hold for
3 seconds. On other models, touch the
CLOCK pad.
Touch the number pads.
Touch the START pad.
After touching the START pad, SET disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
When the Kitchen Timer reaches :00 ,
the control will beep 3 times followed
by one beep every 6 seconds until
the TIMER/CLOCK or TIMER pad
(depending on model) is touched.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
If the remaining time is not in the
display (clock, delay start or cooking
time are in the display), recall the
remaining time by touching the
TIMER/CLOCK or TIMER pad (depending
on model) and then touching the
number pads to enter the new
time you want.
To unlock the control, touch and
hold CONTROL LOCK for 3 seconds.
The CONTROL LOCK mode affects all
touch pads. No touch pads will work when
this feature is activated.
17