Sleep Function; Care And Maintenance - Jensen JMC-180A User Manual

Wall mountable cd system with digital am/fm stereo receiver
Table of Contents

Advertisement

NOTE
There is a PM INDICATOR located on the left-hand side of the clock display. Be sure to observe the PM indicator
when setting the alarm to make sure the alarm time is set correctly for AM or PM. If the PM indicator appears in LCD
DISPLAY, the alarm will be "PM". If not, the alarm time will be "AM".
The Alarm function will be temporarily disabled when the system is turned On, and will resume again when set to
Standby Mode.
Any time the system loses power or is disconnected from the AC outlet, the Alarm settings will be lost and will need to
be reset once power is restored.
TURNING ALARM FUNCTION ON/OFF
1.
Press the AL.ON/OFF Button (#7) once to turn the alarm function on. The ALARM INDICATOR
in the DISPLAY.
2.
Press the AL.ON/OFF Button (#7) again to turn the alarm function off. The ALARM INDICATOR
disappear in the DISPLAY.
CHECKING THE WAKE UP TIME
Whenever you want to check the wake up time, simply press the AL SET button (#10) once while in Standby Mode.
The display will change from current time to wake up time and last about 5 seconds.
This function allows you to program the system to turn itself OFF after a set period of time. You can set your sleep
time while in Power ON mode:
1. To activate the sleep function, press the SLEEP button (#7) repeatedly on the unit, the display will show "OFF
120, 90, 60, 45, 30, 15" and SLEEP icon turn on.
2. When the display shows your desired sleep time, release the button, the sleep timer is now activated. The
display show "15" is to indicate "15 minutes" sleep time and so on. When the sleep time counts to zero, the unit
will go off.
1.
Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used.
2.
Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
3.
Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors.
4.
If drop-outs or interruptions occur in the music during CD play, or if the CD fails to play at
all, its bottom surface may require cleaning. Before playing, wipe the disc from the center outwards with a good
soft cleaning cloth.

SLEEP FUNCTION

CARE AND MAINTENANCE

E-13
֠
will appear
֠
will

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents