Erasing Programs - LEXIBOOK GC500i Instruction Manual

BASE-N mode
Function calculations cannot be performed.
G
Units of angular measurement cannot be specified.
G
All program commands can be used.
G
Be sure to include a "
G
program execution is terminated. Failure to do so may result in a decimal display or an error.
SD1, SD2 mode
Among the functions, Abs and e
G
Among the program commands, Dsz, > and < cannot be used.
G
Mode LR1, LR2
Among the functions, Abs and
G
Among the program commands, →, =, ≠, Isz, > , < , Dsz, < and > cannot be used.
G

4.6 ERASING PROGRAMS

Erasing of programs is performed in the PCL mode. Press
methods used to erase programs: erasing a program located in a single program area and erasing all programs.
4.6.1 Erasing a single program
To erase a program in a single program area, specify the PCL mode and press the
specifying the program area.
Example: erase the program in P3 only.
MODE 3
AC
MODE 1
4.6.2 Erasing all programs
To erase all programs stored in program areas 0 through 9, specify the PCL mode and press
the .
Mcl
Example: erase the programs stored in P0, P4, P8 and P9.
3
MODE
MODE Mcl
MODE 1
Copyright L 2002
EXIBOOK
" at the final result output to return to the previous calculation mode when a
√ cannot be used.
3
√ cannot be used.
3
to specify the PCL mode. There are two
3
MODE
PCL
302
P_12_45678_
PCL
302
P_12_45678_
BASE-N
345
P_12_45678_
_
PCL
273
P_123_567_ _
PCL
400
P0123456789
_
GB
key after
AC
P0,P3 and P9 already contain
programs
Align cursor with P3
Number 3 appears after
deletion
Return to RUN mode
and
SHIFT
- 55 -