General Information; Installation; Door Removal - Viking Vgcc5366bss Installation Manual

General Information

READ AND FOLLOW ALL WARNING Moving, Handling, and Unpacking
AND CAUTION INFORMATION WHEN Remove and discard all packing materials,
INSTALLING THIS APPLIANCE. including cardboard and tape on the outside
and inside of the range.
• All openings in the wall behind the
appliance and in the floor under the Remove the burner grates and styrofoam
appliance must be sealed. off the top cooking surface. Be sure to
remove the burner caps packaged in
• Do not obstruct the flow of combustion and styrofoam below the burner grates.
ventilation air.
Do not discard the anti-tip metal
CAUTION
bracket supplied with the range.
Avoid any damage to oven vents. The vents
This is the anti-tip device and must
need to be unobstructed and open to provide
be installed with the unit. Refer to
proper airflow for optimal oven performance.
"Anti-tip Device Installation"
section.
CAUTION
Some stainless steel parts may have a plastic
The cooling fan should be operating when
protective wrap which must be peeled off.
the unit is in operation. If you notice the
The interior should be washed thoroughly
cooling fan is not operating or you observe
with hot, soapy water to remove film
unusual or excessive noise coming from the
residues and any dust or debris before being
cooling fan, contact a Viking Authorized
used, then rinsed and wiped dry. Solutions
Service Center before continuing operation.
Failure to do so can result in damage to the stronger than soap and water are rarely
oven or surrounding cabinets.
needed.
14

Installation

NOTICE
DO NOT use the handle or oven door to
lift the oven. Remove door before
installation to ensure that it is not used to
lift the unit. DO NOT lift or carry the door
by the handle.
Removing the door must be done by your
dealer, a qualified licensed plumber, or
certified gas installer.

Door Removal

1
Open door completely. Place pins, supplied with unit, in
pin hole. For personal safety, ONLY use pins
supplied with the unit.
3
Close until pins stop door.
15
2
Remove hinge trim screws. Take off hinge trim. Identify
right and left hinge for future re-installation.
4
Lift door up and out.