Fujitsu ScanSnap S1300i Getting Started page 6


Using the Power Cable
1. Connect the power cable
connector of the ScanSnap, and plug it in the
AC outlet.
2. Connect the USB cable
connector on the ScanSnap and the USB
port on your computer.

Using the USB Bus Power Cable
1. Connect the USB bus power cable
power connector on the ScanSnap and the
USB port on your computer.
2. Connect the USB cable
connector on the ScanSnap and the USB
port on your computer.
to the power
to the USB
to the
to the USB
6
4.
Open the ADF paper chute (cover) of the
ScanSnap.
ADF paper
chute
(cover)
 The ScanSnap is powered on and the
[Scan] button lights in blue.
ATTENTION
The bottom part of the ScanSnap may

become hot when the ScanSnap is being
used but this does not affect ScanSnap
operation or cause any physical harm. Be
careful not to drop the ScanSnap when
carrying it.
When the ScanSnap is turned on and left

unused for 4 hours, it will turn itself off
automatically. To turn the ScanSnap
back on, perform one of the following
operations:
- Press the [Scan] button
- Close the ADF paper chute (cover) and
open it again
The time until power-off can be changed.
For details, refer to the Operator's Guide.
5.
Check the ScanSnap Manager icon.
 The ScanSnap Manager icon
USB bus powered connection) is
displayed in the menu that appears when
you click on the taskbar.
To have the ScanSnap Manager icon
( for USB bus powered connection)
always displayed on the taskbar, drag the
icon and drop it onto the taskbar.
[Scan] button
( for