Motorola WR850GP User Manual page 54

Configuration
Field
PPPoE Access Sets the name of the PPP access concentrator, as may be required
Concentrator: by some ISPs.
(ADVANCED)
FACTORY DEFAULT:
PPPoE Connect Sets whether the PPP connection should be automatically
on Demand: disconnected if no traffic has been observed for the period specified
by PPPoE Max Idle Time.
(ADVANCED)
FACTORY DEFAULT:
PPPoE Max Idle Sets the number of seconds to wait before disconnecting the PPPoE
Time: connection if PPPoE Connect on Demand is Enabled.
(ADVANCED) This value can be anywhere between 1 and 3600 seconds.
FACTORY DEFAULT:
PPPoE Keep Sets whether or not the PPPoE connection should be automatically
Alive: restored if it is lost.
(ADVANCED)
FACTORY DEFAULT:
PPPoE MRU: Sets the maximum number of bytes that the PPPoE connection will
receive in a single Ethernet frame.
(ADVANCED)
This value can be anywhere between 128 and 9999 bytes.
FACTORY DEFAULT:
PPPoE MTU: Sets the maximum number of bytes that the PPPoE connection will
transmit in a single Ethernet frame.
(ADVANCED)
This value can be anywhere between 128 and 9999 bytes.
FACTORY DEFAULT:
WR850
(blank)
• Selecting Enabled engages this automatic disconnection.
• Selecting Disabled suppresses automatic disconnection.
Disabled
60
• Selecting Enabled automatically restores lost connections.
• Selecting Disabled suppresses automatic re-connection.
NOTE: This setting has no effect unless PPPoE Connect on Demand
(above) is Disabled.
Disabled
1492
1492
Description
Section 3
3-21