Hitachi KP-D5000 Operation Manual page 23

Lens open setting
Use the Up and Down buttons to move the cursor to
LENS OPEN and push the Set button to change the setting as
follows.
Set button：OFF→ON
Lens is fully open at ON.
Full open
It is the setting to open the auto iris lens at the time of
flange back adjustment. AES operates with this setting.
Set the shutter speed to 1/100 when using it at region
where the power supply frequency is different under the
lighting such as fluorescent lamps where the flicker
phenomenon is generated.
SYNC MODE display
Current synchronous mode is displayed. In case of external
synchronization signal input, it is automatically changed to EXT
mode.
INT：INT mode
EXT：EXT mode
Return to camera factory setting
Bring ther cursor to CAM-RESET and simultaneously press
the Up and Down buttons for 2 seconds, all kinds of settings of
the camera are returned to the factory setting. After end, it
returns to the main menu.
Refer to the explanation of factory setting of each item.
Kanji characters
The various kanji characters, which can be displayed in
camera title, are mentioned below. Other kanji characters can
not be displayed. (Addition and modification in the
following kanji list in not possible.)
Usable Kanji characters
一二三四五六七八九十上下左右東西南北高中低正
副大小前後内外新旧入出両付位交供停側備全処券
力区却原取口台号周室地坂坑埠場塔塵壁売変字守
専屋山岸峠川差常床庫所扉投排改散方施景棟構橋
次止段気水池沈河流海測港湖湾漢火灰炉点焼煙玄
理用田画番発砂砕破監礼突第算管精給線置般衛装
視観計設車貯路辺近退通道部配門閉開関防除陸階
雪電非面頭駅駐
External synchronization signal specification
NTSC
Sync
Frequency
Signal
HD 15.734kHz
VD 59.94Hz
PAL
Sync
Frequency
Signal
HD 15.625kHz
VD 50Hz
H-PHASE selection
The horizontal position of image output at the time of
External synchronization singal input. The optimum setting
has been set at the factory. If necessary, this can be
changed as follows.
Use the Up and Down buttons to move the cursor to
H-PHASE and push the Set button. Right side setting value
blinks. In this state, push the Set button to change
H-PHASE.
Adjustment value range： ： ： ： -128～ ～ ～ ～ 000～ ～ ～ ～ +127
Simultaneously press the Up and Down buttons for 2
seconds to return to the factory setting(000).
39
Note
The character font size of kanji is 18 dot(height) x 12
dot(width). Therefore, the contour, curved line, little
rough part and the narrow part between the character
might not displayed clearly. When using, confirm the
character display quality. The actual display image is
attached below.
40
Input amplitude
Polarity
level
Negative
2～5Vp-p
Negative
2～5Vp-p
Input amplitude
Polarity
level
Negative
2～5Vp-p
Negative
2～5Vp-p