Hitachi KP-D5000 Operation Manual page 21

Gamma correction setting (GAMMA)
Use the Up and Down buttons to move the cursor to GAMMA
and push the Set button to set gamma correction to
ON/OFF/HIGH. Factory setting is ON.
Set button： ON→HIGH→OFF
ON : Gamma ON
HIGH : Gamma ON (High)
OFF : Gamma OFF
Picture polarity setting (POLARITY)
Use the Up and Down buttons to move the cursor to
POLARITY and push the Set button to toggle between
POSITIVE and NEGATIVE. The NEGATIVE polarity is
convenient when using subject of negative polarity such as
negative film. The factory setting is POSITIVE.
Image mirror setting (MIRROR)
Use the Up and Down buttons to move the cursor to MIRROR
and push the Set button to toggle between ON and OFF.
The factory setting is OFF.
Fog adjustment (FOG ADJUST)
Fog adjustment is function to correct image using image
processing, when mist is introduced in the image depending on
picture shooting conditions.
The factory setting is OFF. Move the cursor to FOG ADJUST
and push the Set button to change setting as follows.
Set button：OFF→AUTO→MANUAL
：Fog adjustment is inactive.
OFF
：The correction strength is changed
AUTO
automatically with picture conditions.
In AUTO operation, effect is high, when mist
is subjected to the whole screen and effect
is low, when mist is subjected to a part of
the subject.Fog adjustment is done
automatically.
MANUAL ：Set the correction strength with the picture
shooting conditions.
1) Use the Up and Down buttons to move the cursor to FOG.
2) Set the fog adjustment to MANUAL and simultaneously press
the Up and Down buttons for 2 seconds to display the fog
adjustment menu [FOG SETTING MENU].
35
◆ ◆ ◆ ◆ ＦＯＧ ＦＯＧ ＳＥＴＴＩＮＧ ＳＥＴＴＩＮＧ
ＦＯＧ ＦＯＧ ＳＥＴＴＩＮＧ ＳＥＴＴＩＮＧ
> > > >
S S S S CRVADJ CRVADJ
CRVADJ CRVADJ
ＲＥＴ ＲＥＴ
ＲＥＴ ＲＥＴ
ＥＮＤ ＥＮＤ ＥＮＤ ＥＮＤ
FOG SETTING menu
Correction strength adjustment (SCRVADJ)
The optimum setting has been set at the factory.
If necessary, this can be changed as follows.
Use the Up and Down buttons to move the cursor to
SCRVADJ and push the Set button. Right side setting value
blinks. In this state, push the Set button to change setting.
Adjustment value range： ： ： ： 000～ ～ ～ ～ 015
Note
1) When uniform subject is being captured, correction is
done even if there is no mist.
2) There might be noise with this function, depending on
the picture shooting conditions.
3) Block noise might be seen due to automatic
processing of this function.
36
ＭＥＮＵ ◆ ◆ ◆ ◆ ＭＥＮＵ
ＭＥＮＵ ＭＥＮＵ
： ： ： ： 015 015 ......STRENGTH adjustmennt
015 015
......Return to Sub menu
......End(Menu display off）