Parts And Functions - Fujitsu scansnap s1300i Basic Operation Manual

Parts and Functions

This section explains the names and functions of the ScanSnap parts.
Front
No. Name
1 ADF paper chute (cover) (*1)
2 ADF top section
3 Extension
4 Side guide
5 ADF release tab
6 [Scan] button (*1)
*1: When the ScanSnap has turned off automatically because of the automatic power off function,
either press the [Scan] button (this will not start scanning), or close the ADF paper chute (cover),
then open it again to turn the ScanSnap back on.
For details, refer to
Description
Open it to use the ScanSnap.
Opening it turns on the ScanSnap. Then, you can load a document
on it.
Open it to remove jammed documents, replace the Roller Set, or
clean the inside of the ScanSnap.
Pull out when scanning long documents.
Adjust to the width of documents to prevent them from getting
skewed.
Pull this tab to open the ADF top section.
Starts scanning.
Indicates the status of the ScanSnap as follows:
Blue (lit): Ready
Blue (flashing): Scanning
Orange (flashing): Error
"Automatic Power OFF" (page
1
2
3
4
5
6
43).
29
Parts and Functions