Specifications - Fender '65 SUPER REVERB Instruction Manual

     
R. IEC POWER SOCKET - The line cord must be
connected to a grounded AC receptacle in accor-
dance with the voltage and frequency ratings as
specified on the rear panel of the unit.
S. FUSE - Replace a blown fuse only with a fuse of
the type and rating as specified on the rear panel
of the unit. If the amp repeatedly blows fuses,
have the unit tested by an authorized Fender
service technician.
T. POWER - Switches the unit ON and OFF.
U. STANDBY - In standby mode, power is supplied
only to the tube filaments to keep them warm and
ready to operate. Use standby during short
breaks to eliminate warm-up time and extend the
life of the tubes.
V. MAIN SPEAKER JACK - This is the primary
speaker connection. Speakers (internal or
external) must always be connected here while
operating the unit.

Specifications:

TYPE:
PART NUM BERS:
POWER REQUIREMENTS:
FUSE TYPE
IM PEDANCES
SPEAKER COMPLEMENT:
DIM ENSIO NS
W EIGHT:
¶   6 8 3 ( 5 5 ( 9 ( 5 %        
PR 469
021-7600-000, 120V, 60Hz (USA), 021-7660-000, 230V, 50Hz (Europe),
021-7640-000, 230V, 50Hz (UK), 021-7630-000, 240V, 50Hz (Aust),
021-7670-000, 100V, 50-60Hz (Japan)
270W
120V m odels: 3A, fast-blow, 125V m inim um ,
230-240V m odels: 1. 6A, fast-blow, 250V m inim um ,
100V m odels: 3A, fast-blow, 125V m inim um
Inputs 1: 1M ohm s (both channels)
Inputs 2: 136K ohm s (both channels)
O utput: 2 ohm s
Four 10 in. (25.4 cm ) vintage reissue, P/N 055613
Height: 24 7/8 in.
W idth: 25 1/8 in.
Depth: 10 1/2 in.
65 lbs.
Product Specifications are subject to change without notice.
W. EXTERNAL SPEAKER JACK - Plug in external
speakers here. This jack is wired in parallel with
the main speaker jack.
*** NOTE: The amp is optimized for a 2 ohm
speaker load, which is the rating of the
internal speaker configuration. If a speaker
load other than 2 ohms is used, the amplifier
will distort before reaching maximum output,
and the life of the tubes will be reduced. Two
external 4 ohm speaker cabinets would
provide the recommended 2 ohm load.
X. FOOTSWITCH - Plug the included footswitch in
here. The footswitch enables on/off switching of
the vibrato and reverb effects.
*** NOTE: Vibrato will NOT work without the
footswitch connected, but the reverb effect
will.
Y. REVERB OUTPUT / INPUT - RCA jack connec-
tions for routing the reverb signal to and from the
reverb pan.
(63. 2 cm )
(63. 8 cm )
(26. 7 cm )
(24. 3 kg)
5