Table of Contents
Advertisement
GLASS & SCREEN ASSEMBLY REMOVAL
1.
Remove the two screws securing the screen assembly to the
firebox. Lift the assembly up and pull out to remove it from
the firebox. See Figure 12.
2.
Secure the glass assembly in place with one hand.
3. Insert the Latch Tool into the firebox at the top and hook it
onto the right glass clip.
4.
Using steady force, pull the latch out and up until it disen-
gages from the glass assembly.
5.
Repeat step 4 for the left glass clip.
Top glass clips are tightly sprung. If the Latch tool slips off of
the clip while pulling, injury may occur. Ensure that the latch
tool is completely hooked around the glass clips before trying
to disengage the glass clips from the glass assembly.
NOTICE: Latch tool must be stored near unit.
34961-2-1015
Figure 12
Figure 13
CAUTION
6. Angle the glass towards you from the top and firmly pull out.
Bottom glass clips do not require use of the latch tool to disen-
gage them from the glass assembly. However, they are tightly
sprung and some force is needed to disengage them from the
glass assembly.
CAUTION
Figure 14
Page 13
Advertisement
Table of Contents
