Glass Placement - Empire Comfort Systems Boulevard MULTIFUNCTION REMOTE DVLL60BP90N-2 Installation Instructions Manual

Direct vent zero clearance gas fireplace heater
Hide thumbs Also See for Boulevard MULTIFUNCTION REMOTE DVLL60BP90N-2:
Table of Contents

Advertisement

Preparation of fireplace prior to decorative media placement
1.
DVLL60BP: The accent glass panels are wrapped and
secured to the burner cover assembly with a cable tie for
shipping purposes. Cut the cable tie, then remove and set
aside the accent glass panels.
Turn off all power to the fireplace prior to changing bulbs
or servicing the controls.
2. If a liner kit has not been installed, STOP and install one
before proceeding with media placement.
3.
Remove the light cover and verify that the accent light bulbs
are installed in the light bracket. These are located in the
reflective light bracket at the front of the firebox. Use gloves
or a soft cloth to verify the light bulbs are plugged correctly.
Do not handle halogen bulbs with your bare hands. Oils from
your skin will cause the bulb to burn out prematurely.
4.
Install the two accent glass panels into the metal retainer
bracket located above the accent lights. The two glass
panels will be placed so they meet together at the center of
the bracket.
5.
Replace the light cover over the accent lights.
6.
If applicable, install Logs and Rock kit.
41117-0-0819

GLASS PLACEMENT

CAUTION
ACCENT LIGHT COVER
DO NOT COVER WITH
CRUSHED GLASS MEDIA
7.
Add the decorative crushed glass media of your choice at
this time. Crushed glass may cover the complete burner
cover, accent glass panels, and burner screen.
Place crushed glass media over the burner screen in a single
layer. Use just enough crushed glass media to mask the burner
screen (approximately 1 sq. ft.). Additional crushed glass may
be placed over the burner cover and accent light glass panels as
shown in Figure 68.
Glass Quantity:
DVLL60BP: Use up to (7 sq. ft. of 1/4-inch) crushed glass.
BURNER COVER
CRUSHED GLASS
MEDIA ALLOWED
CAUTION:
DO NOT
GLASS MEDIA IN THE RECESSED
AREA AROUND THE PILOT, PILOT
SENSOR, OR IGNITOR PROBE
ACCENT LIGHT GLASS PANELS (DVLL60)
ACCENT LIGHT COVER (DVLL48)
CRUSHED GLASS MEDIA ALLOWED
Figure 68
PLACE CRUSHED
Page 37

Advertisement

Table of Contents
loading

Table of Contents