Table of Contents
Advertisement
VLANs
Tag-based VLAN Mode
Port-based VLAN Mode
V
L
A
N
c
o
m
m
a
n
d
V
L
A
N
c
o
m
m
a
n
d
All VLAN configurations are also available from the webUI.
vlan config default
vlan enable/disable
vlan add
vlan delete
vlan name
vlan membership add
vlan membership egress
vlan membership delete
vlan interface ingress
vlan interface egress
vlan interface igmp
vlan interface mgmt
vlan mode
Motorola, Inc.
Tag based mode is fully 802.1Q VLAN compliant. You must explicitly configure the
Egress and Ingress rules for each port and each VLAN. On the webUI, use the 802.1Q
TAG-BASED VLAN menu to configure VLANs.
The mT2 Switch and m2 WallPlate can operate independently. Be sure to configure all
ports on the Switch and the WallPlates for proper operation. Consult one of the VLAN
Tutorials.
Port based VLAN is also called Port Isolation or Port Privacy in other switches.
When operating in port-based mode, the T2 Switch will ignore 802.1Q VLAN tags. Port
isolation is based on a VLAN Map. On the webUI, use the PORT-BASED menu to see
the VLAN Map and change the mapping. See below for more details.
Note: The Switch operates in port-based mode; whereas the WallPlates only operate
in tag-based, or disabled. This allows for special case configurations where the
WallPlates do all the 802.1Q VLAN tagging, while the Switch maintains port-to-port
privacy.
s
i
n
m
T
2
s
i
n
m
T
2
Restore VLAN configuration to default
Enable or disable VLAN support. Requires a system reboot after issuing this command.
Create or modify a VLAN.
Delete a VLAN Group. Remove all ports that are members of the group before deleting
the group.
Enter a friendly name for the VLAN
Add or delete a VLAN from a port. Allows the VLAN to transmit on the port
Sets how a VLAN will egress; with a tag or without. By default, packets will transmit
untagged unless specified using this command. Note this command does NOT apply to
WallPlate ports
Deletes a port from a VLAN membership
Ingress command: Assign the PVID for a port. This VLAN ID will be assigned to all
packets received untagged on this port
Set the Egress mode on any CPE port. This command does not apply to mT2 Switch
ports
Assign VLAN for IGMP packets
Assign VLAN for layer 2 security for all management traffic
Set the mode of operation on the Switch and the WallPlates. Options are IEEE 802.1Q
tag-based, or Port-based. Note: WallPlates only support tag-based or disabled.
549453-001-00-a
Page 30 of 51
Advertisement
Table of Contents
