Table of Contents
Advertisement
Hardware
W
a
l
l
P
l
a
t
e
W
a
l
l
P
l
a
t
e
m2a – 2 port WallPlate
Designed to be installed over existing RJ11 wall jack. Bracket has a large opening to route the RJ11 cable from the
existing jack. See Installation Chapter for a breakout view of the cover and bracket.
m4a – 4 port WallPlate
Designed to be installed over existing RJ11 wall jack. Bracket has a large opening to route the RJ11 cable from the
existing jack.
m4a – 4 port Service Unit
Designed to be set on a shelf, or mounted on flat surface. Not designed for installation over an existing RJ11 jack.
The mounting bracket is solid, there is no hole to route an RJ11 cable behind the unit. The line-in RJ11 jack is
located on the external side of the unit. The Service Unit does not have an integrated POTS filter.
Motorola, Inc.
DC power connector (not used from 0 to 600meters)
RJ11 filtered phone port
Eth1 – 10/100 auto-sensing Ethernet
Eth2 – 10/100 auto-sensing Ethernet
RJ11 line-in port (not shown, accessible when bracket is removed)
DC power connector (not used from 0 to 600meters)
RJ11 filtered phone port
Eth1 – 10/100 auto-sensing Ethernet
Eth2 – 10/100 auto-sensing Ethernet
Eth3 – 10/100 auto-sensing Ethernet
Eth4 – 10/100 auto-sensing Ethernet
RJ11 line-in port (not shown, accessible when bracket is removed)
DC power connector (not used from 0 to 600meters)
RJ11 line-in port
Eth1 – 10/100 auto-sensing Ethernet
Eth2 – 10/100 auto-sensing Ethernet
Eth3 – 10/100 auto-sensing Ethernet
Eth4 – 10/100 auto-sensing Ethernet
549453-001-00-a
Page 12 of 51
Advertisement
Table of Contents
