Change Engine Oil And Filter; Replace Spark Plugs; Check Engine Oil Level; Clean Air Screen - Ariens 915013-1742 EZR Owner's/Operator's Manual

• Remove packed grass and debris from under
mower deck.
• Keep finished surfaces and wheels free of all
gasoline, oil, etc.
• Protect painted surfaces with automotive type
wax. Lightly coat unpainted surfaces with spray
lubricant and wipe off excess with soft cloth.
IMPORTANT: Never spray unit with water or store unit
outdoors. Water can seep into sealed bearings, which
are sealed against dirt and debris only, causing
reduced component life.
ENGINE
To access engine:
1. Unhook Engine Cover latch.
2. Lift rear of cover and slide out. Set cover aside.
3. To replace cover: Slide front of cover into slot.
4. Insert the back edge of cover into its support
bracket.
5. Hook Engine Cover latch securely.
Fuel Cap
Engine Cover

CHECK ENGINE OIL LEVEL

Check the crankcase oil level before starting the engine
and after each eight (8) hours of operation. Tighten oil
fill cap/dipstick securely each time you check the oil
level. See Engine Manual for detailed instructions.
Operating
Range
IMPORTANT: To prevent extensive engine wear or
damage, always maintain the proper oil level. Never
operate the engine with the oil level below the "L" mark
or over the "F" mark on the dipstick.

CHANGE ENGINE OIL AND FILTER

CHECK AIR FILTER
This engine is equipped with a replaceable, high
density paper air cleaner element and an oiled, foam
precleaner.
Check the air cleaner daily or before starting engine.
Check for buildup of dirt and debris around the air
cleaner system. Keep this area clean. Also check for
loose or damaged components. Replace all bent or
damaged air cleaner components.
Your engine will not run properly with a dirty air filter.
See Engine Manual for detailed instructions on
changing the air filter.
IMPORTANT: Operating the engine with loose or
damaged air cleaner components could allow unfiltered
air into the engine causing premature wear and engine
Engine
failure.
Cover
Latch
INSPECT MUFFLER/SPARK ARRESTOR
Inspect muffler and (if equipped) spark arrester.
Replace muffler if corroded, as it could create a fire
hazard and/or damage.

REPLACE SPARK PLUGS

See Engine Manual for detailed instructions.
REPLACE IN-LINE FUEL FILTER
OE0800
The fuel filter should be replaced once each season. If
fuel filter becomes clogged, obstructing fuel flow to
carburetor, replacement is required. See Engine
Manual for detailed instructions.

CLEAN AIR SCREEN

Air screen must be kept free of dirt and chaff to prevent
engine damage from overheating. Clean with a brush
"FULL" Mark
or cloth to remove dirt and chaff. Do not clean with a
forceful spray of water because water could
contaminate fuel system. See Engine Manual for
detailed instructions.
OE0380
CLEAN ENGINE COOLING FINS
To ensure proper cooling, make sure the grass screen,
cooling fins and other external surfaces of the engine
are kept clean at all times. See Engine Manual for
detailed instructions.
IMPORTANT: Operating the engine with a blocked
grass screen, dirty or plugged cooling fins, and/or
engine shroud removed will cause engine damage due
to overheating.
GB - 20
• Only use high quality detergent oil rated with API
service classification SF or SG. Select the oil's
SAE viscosity grade according to your expected
environmental temperature.
• See Engine Manual for detailed instructions.