Motorola im240 User Manual page 34

Safety and General Information
• Ministry of Health (Canada). Safety Code 6. Limits of Human
Exposure to Radiofrequency Electromagnetic Fields in the
Frequency Range from 3 kHz to 300 GHz, 1999.
• Australian Communications Authority Radiocommunications
(Electromagnetic Radiation - Human Exposure) Standard 2003
• ANATEL, Brasil Regulatory Authority, Resolution 303 (July 2, 2002)
"Regulation of the limitation of exposure to electrical, magnetic, and
electromagnetic fields in the radio frequency range between 9 kHz
and 300 GHz." "Attachment to Resolution 303 from July 2, 2002."
The iM240 modem card has been tested for compliance with FCC / IC
RF exposure limits in laptop computer configurations with side PCMCIA
slots, and palmtop computers with rear PCMCIA slots, and can be used
in laptop computers and palmtop computers with substantially similar
physical dimensions, construction, and electrical and RF
characteristics.
Your wireless modem is designed and manufactured to operate with the
antenna in the vertical position. To assure optimal radio product
performance and make sure exposure to radio frequency
electromagnetic energy is within the guidelines set forth in the above
standards, be sure always to put the antenna in the vertical position
when operating the wireless modem in any computer that is sitting on
your body.
Approved Accessories
For a list of approved Motorola accessories call 1-800-453-0920, or visit
our website at www.motorola.com/iden
ALL MODELS WITH FCC ID AZ489FT5834 MEET THE GOVERNMENT'S
REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
Your wireless modem is a radio transmitter and receiver. It is designed and
manufactured not to exceed the emission limits for exposure to radiofrequency
(RF) energy set by the Federal Communications Commission of the U.S.
Government. These limits are part of comprehensive guidelines and establish
permitted levels of RF energy for the general population. The guidelines are
based on standards that were developed by independent scientific organizations
through periodic and thorough evaluation of scientific studies. The standards
include a substantial safety margin designed to assure the safety of all persons,
regardless of age and health.
The exposure standard for wireless modems employs a unit of measurement
known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is
1.6W/kg. Tests for SAR are conducted using standard operating positions
1
reviewed by the FCC with the modem transmitting at its highest certified power
level in all tested frequency bands. Although the SAR is determined at the highest
certified power level, the actual SAR level of the modem while operating can be
26