Mazda 1975 Rotary Pickup Workshop Manual page 186

T 4
as described in Par. 14-A and l4-B..
2. Remove the rear view mirror and sun visor.
3. Pull the headlining loose from the cemented area
at the windshield headers and the door openings.
4. Disengage the front and center listing wires from
the holes in the left and right roof rails.
5. Remove the interior lamp attaching screws, dis-
connect the wire and remove the interior lamp.
6. Remove the screws that attach the rear listing
wire brackets to the back plate.
7. Pull the rear listing wire upward and remove the
headlining from the vehicle.
14-D-2. Installing Headlining
1. Beginning at the rear, insert both ends of rear
listing wire into the holes of the back plate, as
shown in Fig. 14-13.
6. Wait until it becomes tacky, then cement
headlining in place at front and rear, stretching
headlining to make it taut.
the
the
Install the fixing brackets,
::. to the back plate with
to rear listing attached
bcrews.
7. Trim the material properly at
vent wrinkling, as shown in Fig.
to the pillars.
the corners to pre-
14-17, and cement
Fig. 14-14 Installing listing wire bracket
. hole in the headlining material for the in-
.:np and connect the wire through the head-
the remaining two listing wires into the
:' rails. making sure to stretch the headlin-
.ement to the front and rear headers.
8. Tighten the interior lamp attaching screws.
9. Trim the excess material at the front and rear.
10. Install the rear view mirror and sun visor.
11. Install the windshield glass and the rear window,
as described in Par. 14-A-2.
Fig. 14-15 Installing listing wire
Fig. 14-13 Inserting rear listing wire
Fig. 14-17 Trimming headlining material